Brother PC-8200 User Manual page 36

1
2
5
5
5
34
2. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 5 cm.
1 Upper thread
2 5 cm (1-15/16)
3. While pressing down on the thread and the fabric with your
left hand, turn the balance wheel with your right hand to
move the needle to the sewing start position.
1 Thread
* Sewing can begin without pulling out the bobbin thread.
4. Lower the presser foot. Press the "REVERSE STITCH"
3
button to sew a reverse stitch, and then press the
"START/STOP" button. The machine will start to run at slow
speed.
3
5. When sewing is completed, press the "REVERSE STITCH"
button to sew a reverse stitch.
6. Press the "THREAD CUTTER" button to cut the threads .
*6. Cut thick thread (thicker than # 30) with the cutter on the
side of the machine as illustrated.
* BOBBIN THREAD SENSOR
5
If a warning message appears on the message screen, the
bobbin thread is running out. Replace the bobbin thread at
this time.