Brother PC-8200 User Manual page 113

1
2
3
1
2. Loosen the adjusting screw and separate the inner and
outer frames. Lay the fabric on top of the outer frame and
secure it between the inner and outer frame, and tighten the
adjusting screw just enough to secure the fabric. Gently
remove the fabric from the frame without loosening the
adjusting screw.
1 Inner frame
4
2 Outer frame
3 Adjusting screw
4 Loosen
* This precautionary step will help reduce pattern distortion
while embroidering.
Be sure to align the L mark on the inner frame with the M
*
mark on the outer frame.
1 Tighten
1
3. Place the embroidery sheet into the inner frame, while
matching lines on the sheet with mark on fabric.
2
* For best results lay the outer frame on a flat table surface
and lay the fabric on top of it.
1 Inner frame
2 Standard line
4. Press down into the outer frame so that the mark doesn't
move out of place.
1 Outer frame
2 Inner frame
3 Surface of fabric
* Press down firmly until the outer frame and inner frame are
at the same height.
5. After the fabric is clamped between the inner and outer
frame tighten the adjusting screw by hand.
1 Tighten
* To avoid stripping the screw, do not use a screwdriver to
tighten.
1
2
1
3
111