Changing The Presser Foot; Change The Presser Foot According To The Lcd Message; Installing Embroidery Foot "Q - Brother PC-8200 User Manual

CHANGING THE PRESSER FOOT

Change the presser foot according to the LCD message

1
1

Installing embroidery foot "Q"

5
1. Push the "NEEDLE POSITION" button to raise the needle,
and then turn off the power.
2. Raise the presser foot lever.
2
3. Press the black button located at the back of the presser
foot holder to release the foot.
1 Presser foot holder
4. Place the presser foot pin directly below the holder-end and
lower the presser foot lever.
1 Holder-end
2 Foot pin
1
2
1. Push the "NEEDLE POSITION" button to raise the needle,
and then turn off the power.
2. Raise the presser foot lever.
3. While pressing the black button to the left of the presser foot
holder, pull the presser foot holder downward to remove it.
29