CHANGING THE NEEDLE
Setting the needle securely
1
Checking needle
2
1. Turn off the power and lower the presser foot.
2. Loosen the screw with a screwdriver.
3. Pull out the needle.
4. With the flat side of the needle facing the back, insert the
needle as far as it will go against the needle stopper. Fasten
the screw securely with a screwdriver.
1 Needle stopper
5. Turn the power on.
1. Place the needle on a flat surface and check whether the
space is parallel or not.
2. Flat surface
1
(Needle plate, glass, ruler etc.)
If the space is not parallel then the needle is bent and
should be thrown away to prevent damage to your project or
to the machine.
31