Embroidering From A Specific Starting Point; Changing The Pattern Direction - Brother PC-8200 User Manual

Embroidering from a specific starting point

Changing the pattern direction

ABC
118
CAUTION
After a starting position has been rotated, check the
display to see which embroidery frames can be used. If an
embroidery frame which is not displayed is used, the
embroidery foot may touch the frame, or personal injury
may result.
1. Make a mark at the starting position on the fabric in the
frame as shown in the illustration. The mark cannot be too
close to the edge of the frame as the presser foot prevents
the needle from getting very close to the frame.
2. Touch the "
starting position. (The embroidery frame will move.)
3. Use the arrow keys to align the mark with the hole in the
embroidery foot, and then start embroidering.
The pattern will be rotated clockwise in 90˚ steps as shown in
the illustration at left each time the "
* Some patterns may be too long to be rotated 90°. In such
cases, the patterns can be rotated by 180° only.
CAUTION
After a pattern has been rotated, check the display to see
which embroidery frames can be used. If an embroidery
frame which is not displayed is used, the embroidery foot
may touch the frame, or personal injury may result.
" key. The needle will move to the
" key is touched.