Brother PC-8200 User Manual page 18

2
1
16
4. Guide the thread through the small hole in the side of the
bobbin from the inside. Place the bobbin on the bobbin
winder shaft. While holding the thread end, push the bobbin
winder shaft to the right.
1 Spring on the shaft
2 Groove of the bobbin
* Align the groove of the bobbin with the spring on the shaft.
5. While holding the thread end, press the "START/STOP"
button. Wind the thread a few times around the bobbin and
press the "START/STOP" button again.
Trim the excess thread from the top of the bobbin after the
machine stops.
6. Set the speed to maximum.
7. Press the "START/STOP" button. The machine will stop
automatically when the bobbin is full. Press the
"START/STOP" button to stop at any time or when the
bobbin has stopped moving and the motor is still running.
8. Push the bobbin shaft to the left. Remove the bobbin.
9. Set the bobbin into the shuttle as shown on the next page.