Print Content - General Measure ChexGo CW-60K-V User Manual

00032
00033
00034

Print content

7.3
1. When the communication mode is set to print, connect the printer, click the print
button on the "Statistics" interface, or send the print command through the communication
mode, the output will be as follows:
2. When the communication mode is set to result printing, the device will actively send
data. After each check, it will actively send the content shown in the following figure
through the serial port:
The format is timestamp+weight. If there is an external printing device, the above
content will be printed. The above content is only an example. The specific printed data is
subject to the actual test results.
3、The data format of CHRE mode is as follows：
S leave status
T a
Zero clear (when writing ON, zero clear)
0031
Clear alarm (Clear alarm when there is an alarm written
0032
ON)
Print (when writing ON, print out)
0033
DATE: 2015.10.15
TIME:
PRODUCT CODE:
TARE WT:
UP LIM:
REF WT:
LOW LIM:
PASS CT:
PASS WT:
PASS AVR:
PASS RATE:
OVER CT:
OVER WT:
UNDER CT:
UNDER WT:
TOTAL CT:
TOTAL WT:
MIN WT:
MAX WT:
20140503142100 0.0346kg
Leave sign limit
a
上分隔横线符
打印日期
打印时间
15:21
产品号
1
皮重值
0.000kg
超差值
0.030kg
目标值
8.135kg
欠差值
0.030kg
合格累计次数
1
合格累计重量
8.140kg
合格平均重量
8.140kg
合格率
100.00%
超差累计次数
0
超差累计重量
0.000kg
欠差累计次数
0
欠差累计重量
0.000kg
总累计次数
1
总累计重量
8.140kg
最小值
8.140kg
最大值
8.140kg
上分隔横线符
leave Sampling
a results
-49-
让称重触手可及
Making Weighing More Accessible
Making Weighing More Accessible
unit CRC CR LF