General Measure ChexGo CW-60K-V User Manual page 13

Input (function can be customized, onsite connection according to actual
demand) :
DI1: running input. In the stopped state, the input is valid and the system enters the
running state.
DI2: Stop input. In the running state, the input is valid and the system enters the stop
state.
DI3: clear the alarm. When the system generates an alarm, change the input to be
effective and the alarm will be cleared.
DI4: out-of-tolerance elimination is completed. When the input is valid, the output of
out-of-tolerance elimination is invalid.
DI5: Undererror culling is complete, undererror culling output is invalid when this input
is valid.
DI6: continuous packet detection. This input signal is given by the photoelectric sensor
installed on the front conveyor line of the weighing scale and used in conjunction with the
busy stop output to control the start and stop of the front conveyor line of the weighing
scale. When there is an object being detected on the weighing platform and the signal is
effective, the busy stop output is effective.
DI0V: switching quantity power supply DC24V-.
DI24V: Switching quantity power supply DC24V+.
4 transistor outlet (function can be customized, on-site according to the
actual demand connection) :
DO1: No definition.
DO2: undefined.
DO3: undefined.
DO4: undefined.
DO0V: switching quantity supply power DC24V-.
DO24V: switch quantity power supply DC24V+.
DOCOM: switch quantity common end.
Sensor (already connected at factory) :
EX+ : Power positive, SN+ : induction positive, EX- : power negative, SN- : induction
negative, SG+ : signal positive, SG- : signal negative.
Motor speed control communication interface (RS485) :
Making Weighing More Accessible
-7-
让称重触手可及
Making Weighing More Accessible