Electrical Interface - General Measure ChexGo CW-60K-V User Manual

3
4
5
6
7
8
9
10
11
12
13
14
15
2.4

Electrical interface

Photoelectric sensor (already wired at factory) :
E24V: photoelectric sensor DC24V+.
E0V: photoelectric sensor DC24V-.
E1: Signal input of photoelectric sensor for loading of weighing scale.
E2: Check the output photoelectric sensor signal input of the weight balance.
Alarm light (has been connected when leaving the factory) :
L24V: Alarm light DC24V+, maximum output power 2VA.
L1: Buzzer.
L2: When the detection result is out of tolerance, the low output is valid until the next
check begins.
L3: When the test result is qualified, the low output is valid until the next check begins.
L4: When the detection result is inferior, the low level output is effective until the next
check starts.
External custom output relay K1-K8
Detect the photoelectric sensor wiring terminals
Alarm light wiring terminals
Custom input ports 1-6 externally
Sensor terminal
External RS-485 communication jack
External TCP/IP communication network port
Inverter communication jack
External USB data interface
24V power terminal
Reset key
Communication status indicator
Output relay status indicator light
-6-
让称重触手可及
Making Weighing More Accessible
Making Weighing More Accessible