General Measure ChexGo CW-60K-V User Manual page 40

If not eliminated in
time, the alarm will be
stopped
Busy alarm stop
The time of
overplugging will alarm
and stop the machine
If the maximum time
on the scale is
exceeded, it will alarm
and stop
The number of
consecutive unqualified
alarms
The number of super
continuous
disconformance alarm
stops
Upper limit of motor
load
Stop above the motor
load limit
After the next unqualified product has gone through the
reinspection process, the last product has not been removed,
the alarm will be stopped
In the last product has not been out of the inspection belt, the
next product into the inspection belt, it will show busy alarm
and stop.If the back end is connected with an over and under
error elimination mechanism, the default is over error
elimination
Indicates that if the discharge photoelectric induction
continues, and exceeds the plugging time set in the system
parameter interface, it will alarm and stop
There are two kinds of action;1. If the maximum time on the
scale set on the touch screen is more than 2 times of the time
required for the object to pass the scale, the maximum alarm
time on the scale is twice of the time required for the object to
pass the scale. 2. If the maximum time on the weighing
platform set on the touch screen is less than or equal to twice
the time required for the object to pass the weighing platform,
the maximum alarm time on the weighing platform is the
maximum time on the weighing platform set on the touch
screen
The number of consecutive failed alarms
In the product parameter setting interface, you can set the
alarm number of continuous nonconformance. If the set value
is not zero and the switch is on, the number of continuous
nonconformance will alarm and stop when it reaches this value
The maximum load the motor can withstand
The upper limit of motor load can be set in the system
parameter interface of the product. When the weight of the
-34-
让称重触手可及
Making Weighing More Accessible
Making Weighing More Accessible