Advanced Parameters - FIBARO SMART MODULE Operating Manual

10.2: Advanced parameters

The device enables customizing its operation to user's needs with configurable
parameters.
The settings can be adjusted using a Z-Wave controller to which the device is
added. The way of adjusting them might differ depending on the controller.
In the interface parameters are presented as simple options in Advanced Set-
tings of the device.
Available parameters:
1.
This parameter determines the state of relays after power
supply failure (e.g. power outage).
Description
For the auto OFF and flashing modes the parameter isn't
relevant and the relay always remains switched off.
Parameter size 1B
Default value 1 (restore the state)
0 – relays remain switched off after restoring power
1 – restore the remembered state of relays after restoring
Available power
values
2 – restore the remembered state of relays after restoring
power, but for toggle switches set the same state as the
current state of the switches
20.
This parameter defines as what type the device should
Description
treat the switch connected to the S1 terminal.
Parameter size 1B
Default value 0 (momentary switch)
0 – momentary switch
2 – toggle switch (contact closed - ON, contact opened
Available
- OFF)
values
3 – toggle switch (the device changes status when the
switch changes status)
21.
This parameter defines as what type the device should
Description
treat the switch connected to the S2 terminal.
Parameter size 1B
Default value 0 (momentary switch)
Remember relays state
S1 input – switch type
S2 input – switch type
17
confIguratIon