6: Removing From Z-Wave Network - FIBARO SMART MODULE Operating Manual

10
5. Adding result is confirmed with the Z-Wave controller message and the LED
frame:
• Green – successful (non-secure, S0, S2 non-authenticated mode)
• Magenta – successful (Security S2 Authenticated mode)
• Red – not successful

6: Removing from Z-Wave network

Removing (Exclusion) – Z-Wave device learning mode, enables you to re-
move the device from an existing Z-Wave network. Removing also results in
resetting the device to factory defaults.
To remove the device from the Z-Wave network:
1. Power the device.
2. Set the main controller into the remove mode (for more information, see the
controller manual).
3. Click quickly, three times the maintenance button.
4. LED starts blinking yellow, wait for the removing process to end.
5. Successful removing is confirmed with the Z-Wave controller message and
the red LED color.
removIng from Z-Wave netWork
In case of problems with adding the device, please reset the
i
device and repeat the adding procedure.
Make sure that restoring the parameters to factory defaults
!
won't result in damaging the connected device. We recom-
mend disconnecting the connected device first.