Menu; Resetting To Factory Defaults - FIBARO SMART MODULE Operating Manual

12
• Blinking red – entering the menu (not added to a Z-Wave network)
• Magenta – testing a Z-Wave network range
• Yellow – reset to factory defaults

7.3: Menu

Menu enables performing Z-Wave network actions.
To use the menu:
1. Press and hold the maintenance button.
2. LED signals adding status for 3 seconds (see 7.5: Visual indications),
3. Release the button when device signals desired position with colour:
4. Quickly click the button to confirm.

7.4: Resetting to factory defaults

Reset procedure enables you to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and user
configuration is deleted.
1. Press and hold the maintenance button.
2. Release button when the device glows yellow.
3. Click quickly the button to confirm.
4. After a few seconds the device is restarted, which is signalled with the
operatIng the DevIce
then it turns off for another 3 seconds.
• MAGENTA – testing a Z-Wave network range
• YELLOW – reset to factory defaults
Make sure that restoring the parameters to factory de-
!
faults won't result in damaging the connected device. We
recommend disconnecting the device first.
Resetting the device isn't a recommended way of remov-
i
ing the device from the Z-Wave network. Use reset proce-
dure only if the primary controller is missing or inoperable. Cer-
tain device removal can be achieved with the procedure of
removing described below.
red LED color.