Sharp MultiSync EA272Q User Manual page 21

nOperations after first power-on
Initial Setting of USB FUNCTIONALITY
USB Hub/Type-C function/[USB LAN] in OSD menu are disabled as the default condition set at the factory and in the product's
firmware; performing a FACTORY PRESET returns the function to its default disabled condition for reduced power consumption.
When turning on the monitor for the first time or after FACTORY PRESET, the USB FUNCTIONALITY message is shown. Select
a setting from below. The [USB LAN] settings in OSD menu need to be changed if you use the LAN terminal.
OFF: USB FUNCTIONALITY continues to be disabled.
AUTO: USB FUNCTIONALITY is used when the monitor power is ON.
ON: USB FUNCTIONALITY is used when the monitor power is ON and OFF.
90W: USB FUNCTIONALITY is used when the monitor power is ON and OFF. Changing the power distribution inside the
monitor to make the USB Type-C (upstream) terminal be the main power supply. There are some function limitations
when set to [90W]. Please refer to [USB FUNCTIONALITY]
Touch "<" and ">" keys for setting then touch "MENU/EXIT" key to close the message.
After this Initial Setting, another selection is possible by OSD menu.
nAutomatic input switching function
When connecting signal cables to the monitor, the active input is automatically switched to the newly connected input if [VIDEO
DETECT] is set to [FIRST] (See page 27).
(page 28) for more detail.
English−21
Turning Power On/Off