Table of Contents
Advertisement
Picture is not bright
•
If the brightness fluctuates, make sure [DV MODE] is set to [STANDARD].
•
Make sure [ECO MODE] and [AUTO BRIGHTNESS] are turned off.
•
If the brightness fluctuates, make sure [AUTO BRIGHTNESS] is turned off.
•
Make sure the signal cable is fully connected to the monitor and the computer.
•
LCD brightness degradation occurs due to long-term usage or extreme cold conditions.
•
When using an HDMI input terminal, please change [VIDEO LEVEL] (see
•
Change setting of the [USB FUNCTIONALITY] other than [90W].
Display image is not sized properly
•
Make sure that a Major Supported Timings has been selected for the display card in the system being used.
(Please consult the manual for the system or display card for supported resolution and changing the settings.)
•
When using an HDMI input terminal, please change [OVER SCAN] (see
Brightness variations over time
•
Change [AUTO BRIGHTNESS] to [OFF] and then adjust the [BRIGHTNESS].
•
Change [DV MODE] to [STANDARD] and then adjust the [BRIGHTNESS].
TIP:
When [AUTO BRIGHTNESS] is set to [ON], the monitor automatically adjusts brightness based on the environment.
When the brightness of surrounding environment changes, the monitor will also change.
When [DV MODE] is set to [DYNAMIC], the monitor automatically adjusts brightness based on the video signal.
Displayed OSD menu is rotated
•
Make sure of the [OSD ROTATION] setting.
No picture in multiple monitor connection
•
Check to make sure that the resolution is lower than the recommended resolution setting.
•
Check to make sure that the display card supports MST (multi-stream transport).
•
The number of monitors daisy chained through SST (single-stream transport) depends on HDCP contents limitation.
•
Please use a certified DisplayPort cable.
page
page
26).
English−38
26).
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSync EA272Q and is the answer not in the manual?
Questions and answers