SMC Networks EX260-MEC1 Operation Manual page 8

•Mount the product in a place that is not exposed to excessive vibration or impact.
Otherwise, failure or malfunction can result.
•Do not use the product in an environment that is exposed to temperature cycle.
Heat cycles other than ordinary changes in temperature can adversely affect the inside of the product.
•Do not expose the product to direct sunlight.
If using in a location directly exposed to sunlight, shade the product from the sunlight.
Otherwise, failure or malfunction can result.
•Keep within the specified ambient temperature range.
Otherwise, malfunction can result.
•Do not operate close to a heat source, or in a location exposed to radiant heat.
Otherwise, malfunction can result.
•Use with caution at altitudes above 2000 m, as the reduction in atmospheric pressure reduces
withstand voltage performance and noise immunity. (lightning surge, electro-static discharge)
Adjustment and Operation
•Perform settings suitable for the operating conditions.
Incorrect setting can cause operation failure.
•Please refer to the PLC manufacturer's manual etc. for details of programming and addresses.
For the PLC protocol and programming refer to the relevant manufacturer's documentation.
Maintenance
•Turn off the power supply, stop the supplied air, exhaust the residual pressure and verify the release
of air before performing maintenance.
There is a risk of unexpected malfunction.
•Perform regular maintenance and inspections.
There is a risk of unexpected malfunction.
•After maintenance is complete, perform appropriate functional inspections.
Stop operation if the equipment does not function properly.
Otherwise, safety is not assured due to an unexpected malfunction or incorrect operation.
•Do not use solvents such as benzene, thinner etc. to clean each unit.
They could damage the surface of the body and erase the markings on the body.
Use a soft cloth to remove stains.
For heavy stains, use a cloth soaked with diluted neutral detergent and fully squeezed, then wipe up the stains again
with a dry cloth.
-8-
No.DOC1041432