Adjust Stem - Intense M1 PRO Manual

A
C
28
B
D
S T E P 8

ADJUST STEM

NOTE: There is two mounting position options on
mounting your stem, long 50mm and short 45mm this
will change your stem length by 5mm.
The stem comes pre-installed in the long (50mm)
position. If that is the desired mounting position move
on to STEP 9 of tightening the headset.
To change to the short position, start by using the 6mm
Allen key (A) to remove all 4 of the stem bolts. Locate
the short position on the stem (B) and realign the stem
bolt holes to the upper crown of the fork. Tighten the
stem bolts with the 6mm Allen key (C)
bolts to 8Nm (D).
and torque the
29