SSV Works RG4-Q3V1 Manual page 6

A. Unscrew the two (2) torx screws connecting the dash bracket at the rear
of the dash cavity. Remove the under dash bracket.
NOTE: IT WILL NOT BE RE-INSTALLED.
C. With the RG4 Amp mounting plate set in place, check for any
pinched wiring.
E. Run amp power, and speaker extension cables out through the
grommet that is fixed into the firewall (circled in pink). Be sure
to run the correct end of the cable out through the firewall to
avoid the inability to connect to the speakers.
6
A
B. Move the factory wiring to the rear of the dash cavity. Place the
RG4 Amp mounting plate in the former location of the factory
bracket.
C
D. Fasten down the plate with the factory hardware.
E
B
D