Setting The Communication Specifications - Omron ZS Command Reference Manual

Setting the Communication Specifications

Change the settings of the controller communication specifications for communicating with the
external device by CompoWay/F protocol.
Use USB cable or RS-232C cable to connect ZS Series controllers to external
devices.
For USB cable connection, install Smart Monitor ZS and USB driver beforehand. After
installing Smart Monitor ZS, USB ports are recognized as standard COM ports, and
communication is achieved as with the RS-232C. (Setting the communication
specifications including baud rate is not necessary.)
For details on how to connect cable, refer to the User's Manual for each controller.
1.
Set the mode switch to "FUN"
2.
Select [System] - [Communication] - [Mode] menu.
3.
Select [CompoWay/F].
4.
For RS-232C cable connection, select [System] - [Communication] -
[RS-232C] menu to set the appropriate communication
specifications for the external device.
5.
Save the settings.
Setting the Communication Specifications
CompoWay/F Communication Command Reference
Section 1
1-3
ZS Series