Settings In The Ladder Program Edit Screen; Settings In The Parameter Settings Screen - Omron ZEN Operation Manual

Using Timers (T) and Holding Timers (#)
3-6-1

Settings in the Ladder Program Edit Screen

Timer triggers, reset outputs, and timer inputs are drawn on the Ladder
Program Edit Screen. Settings are made on the Parameter Settings
Screen.
Trigger input
Reset input
Timer address
Timer address Timers: T0 to Tf (16 timers)/ Holding Timers: #0 to #7 (8 timers)
Trigger input T (TRG) Controls the timer trigger output. Triggers the timer when the trigger
Reset input R (RES) Controls the timer reset output. When the reset input turns ON, the
Timer bit Turns ON according to the timer type.
3-6-2

Settings in the Parameter Settings Screen

All Timers Except Twin Timers (X, ■, O, F)
Timer address
Twin Timers (W)
Timer address
76
Timer bit
input turns ON.
present value is reset to 0 and the timer bit turns OFF. Trigger inputs
are not accepted while the reset input is ON.
Timer type
Timer type
TO W M:S A
ON time ON-TIMER
TRG
RES
▲ ▼
to switch the display.
TO W H:M A
OFF time
OFF-TIMER
TRG
RES
▲ ▼
Trigger specification
Timer number
Timer trigger output
Timer reset output
Reset specification
Time up output
Time unit
Monitor enabled/disabled
Set value
Time unit for ON time
Monitor enabled/disabled
Set value
02.10
Time unit for OFF time
01.30
Section 3-6