Omron ZEN Operation Manual page 178

Application Examples
Warming Molding Machines (Weekly Timer and Bit
Logic)
Application
The ZEN can be used to improve molding efficiency by warming up the molding machine
before the work shift starts. This allows molding work to begin immediately at the start of
the work shift.
When work shifts vary, pre-set weekly timers can be selected using a switch.
System Configuration
Molding machine
heating circuit
154
NC
ZEN-
10C1AR-A-V2
10C1AR-A-V2
Q0
SW1 (I0) (Continuous operation)
SW2 (I1) (Pattern 1)
SW3 (I2) (Pattern 2)
SW4 (I3) (Pattern 3)
SW5 (I4) (Stop)
Appendix E