Omron ZEN Operation Manual page 63

Wiring
■
■
I/O lines
Control cables and
power lines
Power cables
Floor Ducts
Leave at least 200 mm between the wiring and the top of the duct, as
shown in the following diagram.
Control cables and
I/O lines
power lines
Conduits
Separate the ZEN I/O lines, power and control lines, and power
cables, as shown in the following diagram.
Control cables and
power lines
I/O lines
Do not run ZEN I/O lines in the same duct or conduit as power lines.
300 mm min.
300 mm min.
Power cables
Metal plate (iron)
Power cables
Section 2-2
200 mm min.
39