Settings In The Parameter Settings Screen - Omron ZEN Operation Manual

Using Counters (C) and the 8-Digit Counter (F)
3-7-2

Settings in the Parameter Settings Screen

Counters (C)
Counter address
8-Digit Counter (F)
Counter address
Note
Reset input R (RES) When the reset input turns ON, the present
Turns ON when the counter has counted out (PV ≥ SV)
Count input
Set value 0001 to 9999 (4 decimal digits) times
Monitor enabled/ A
disabled
D
The speed of the counter depends on whether a filter is used. Refer
to page 104.
Set value 00000001 to 99999999 (4 decimal digits) times
Counter speed H
L
Monitor enabled/ A
disabled
D
Counting Speed
The maximum counting speed of the 8-digit counter is 150 Hz
regardless of whether an input filter is used. The maximum ladder
program capacity, however, may be less than 150 Hz. Calculate
the cycle time (refer to page 130) and confirm the maximum
value returns to 0 and the counter bit turns
OFF. Count inputs are not accepted while the
reset input is ON.
Monitor enabled/disabled
Set value
Operating parameters can be monitored and
settings changed.
Operating parameters cannot be monitored or
settings changed.
Counter speed
Monitor enabled/disabled
Set value
High speed (150 Hz, see note.) (I0 for CPU
Units with DC power supplies only)
Low speed (Depends on whether a filter is
used. Refer to page 104.)
Operating parameters can be monitored and
settings changed.
Operating parameters cannot be monitored or
settings changed.
Section 3-7
79