Installing And Wiring Option Cards; Option Card Models; Installation In Ip00 And Nema 1 / Ip20 Inverters - Omron VARISPEED E7 User Manual

Installing and Wiring Option Cards

Option Card Models

Option cards for field bus communications can be mounted in the Inverter like shown in
Table 2.16
Communication cards
PLC Option Card

Installation in IP00 and NEMA 1 / IP20 Inverters

Before mounting an Option Card, remove the terminal cover and be sure that the charge indicator inside the
Inverter does not glow anymore. After that remove the Digital Operator, front cover and the option clip. Then
mount the Option Card.
Preventing Option Card Connectors from Rising
After installing the Option Card insert the Option Clip to prevent the side with the connector from rising. The
Option Clip can be easily removed before installing the card by holding onto the protruding portion of the Clip
and pulling it out.
2-38
lists the type of Option Cards and their specifications.
Card
3G3RV-PDRT2
3G3RV-P10ST8-E
3G3RV-P10ST8-DRT-E
CN2
C Option Card connector
Option Clip
(To prevent raising of
C Option Card)
Fig 2.22 Mounting Option Cards
Table 2.16 Option Cards
Model
Intelligent DeviceNet option card
SI-P1 Option card for Profibus-DP fieldbus
SI-R1 Option card for InterBus-S fieldbus
SI-S1 Option card for CANopen fieldbus
SI-J Option card for LONworks
PLC option card
PLC option card with DeviceNet communications
port (Slave)
Fig 2.22.
Specifications
C Option Card mounting spacer
C Option Card