Table of Contents
Advertisement
26
Installing the VoIP Loudspeaker Amplifier
Upgrade the Firmware and Reboot the Loudspeaker Amplifier
Web Page Item
Application
Load new firmware to Partition 1
New Filename
2.5.1 Reboot the Loudspeaker Amplifier
To reboot a loudspeaker amplifier, log in to the web page as instructed in
Configuration Home
CyberData Corporation
Page".
1. Click Upgrade Firmware to open the Firmware Upgrade page
System section on the right side of the page.
Table 2-13. Firmware Upgrade Parameters
Description
Shows the current application filename for partition 1
and 2.
Enter the TFTP Server IP address.
Enter the new file name for the kernel or application
firmware file that you are uploading.
Click on this button to automatically upload the selected
firmware and reboot the system.
Link to the Speaker Setup page.
Link to the Network Setup page.
Link to go to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Home page.
Click on this button to reboot the system.
930106D
Section 2.3.1, "Log in to the
(Figure
2-15). Use the Reboot
VoIP Loudspeaker Amplifier Operations Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the Part #010861 930106D and is the answer not in the manual?
Questions and answers