Confirm The Ip Address, Test The Audio, And Check The Volume - CyberData Part #010861 930106D Operation Manual

2.2.5 Confirm the IP Address, Test the Audio, and Check the Volume

When the loudspeaker amplifier is operational and linked to the network, use the Reset Test
Function Management (RTFM) switch
and confirm the loudspeaker amplifier's IP Address, test that the audio is working, and check the
volume.
To announce a loudspeaker amplifier's current IP address:
1. Press and hold the RTFM switch until it beeps (after one second).
2. Release the switch to hear the IP address announcement, and check the loudspeaker amplifier
Caution
Equipment Caution: Pressing and holding the RTFM switch for longer than
20 seconds will restore the loudspeaker amplifier to the factory default
settings. See
VoIP Loudspeaker Amplifier Operations Guide
volume.
Section 2.6, "Restore the Factory Default Settings"
(Figure 2-7) on the loudspeaker amplifier face to announce
Figure 2-7. RTFM Switch
930106D
Installing the VoIP Loudspeaker Amplifier
Loudspeaker Amplifier Setup
RTFM switch
.
CyberData Corporation
11