Configure The Loudspeaker Amplifier Parameters; Log In To The Configuration Home Page - CyberData Part #010861 930106D Operation Manual

2.3 Configure the Loudspeaker Amplifier Parameters

To configure the loudspeaker amplifier online, use a standard web browser.
Configure each loudspeaker amplifier and verify its operation before you mount it. When you are
ready to mount a loudspeaker amplifier enclosure, refer to
instructions.
All loudspeaker amplifiers are initially configured with the default IP settings indicated in
When configuring more than one loudspeaker amplifier, attach the loudspeaker amplifiers to the
network one at a time to avoid IP address conflicts.
Parameter
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway

2.3.1 Log in to the Configuration Home Page

1. Open your browser to the speaker IP address.
Note
2. When prompted, use the following default Web Access Username and Web Access Password
VoIP Loudspeaker Amplifier Operations Guide
For the initial configuration of the speaker, open your browser to the default IP address:
http://192.168.3.10
Make sure that the PC is on the same IP network as the loudspeaker amplifier.
to access the Home Page
Web Access Username: admin
Web Access Password: admin
Table 2-7. Factory Default Settings
Factory Default Setting
static
192.168.3.10
admin
admin
255.255.255.0
192.168.3.1
(Figure 2-9):
930106D
Installing the VoIP Loudspeaker Amplifier
Configure the Loudspeaker Amplifier Parameters
Chapter A, "Mounting the Enclosure"
CyberData Corporation
13
for
Table 2-7.