Configure The Sip Parameters - CyberData Part #010861 930106D Operation Manual

Web Page Item
RTFM Announcement
3. After changing the parameters, click Save Settings.

2.3.4 Configure the SIP Parameters

1. Click SIP Setup to open the SIP Setup page
Note
VoIP Loudspeaker Amplifier Operations Guide
Table 2-10. Loudspeaker Amplifier Setup Parameters
a
a.If you select No for RTFM Announcement, you will not hear a beep or associated RTFM audio.
However, the return to default settings function remains active. If you wish to return to default
settings, hold the RTFM button at least 20 seconds, then release the button.
For specific server configurations, go to the following URL:
http://www.CyberData.net/support/voip
Configure the Loudspeaker Amplifier Parameters
Description
Enable/Disable the speaker tone (beep) and audio
associated with the RTFM switch.
Click on this button to save your configuration settings.
Changing a parameter that has an asterisk next to it will
cause a system reboot when saved.
Click on this button to do an audio test. Generates a voice
message for testing the speaker audio quality and volume.
Link to the Network Setup page.
Link to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Upgrade Firmware page.
Link to the Home Page page.
(Figure 2-12).
930106D
Installing the VoIP Loudspeaker Amplifier
CyberData Corporation
19