Restore The Factory Default Settings - CyberData VoIP Loudspeaker Amplifier Part #010859 Operation Manual

2.6 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Each loudspeaker amplifier is delivered with factory set default values for the parameters indicated
in Table
the factory default settings.
When you use the RTFM switch, the factory default settings are restored for only the parameters
indicated in
will remain unchanged.
Parameter
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch for 20 seconds.
2. The loudspeaker amplifier will beep after one second. Continue to hold the switch until the
3. Release the switch. The following occurs:
•
•
•
•
VoIP Loudspeaker Amplifier Operations Guide
2-14. Use the RTFM switch on the loudspeaker amplifier face to restore these parameters to
Table 2-14. The other parameters in the current loudspeaker amplifier configuration
loudspeaker amplifier beeps again after 20 seconds.
A voice message announces that the factory default settings are being restored.
Once the settings are restored, a voice message announces the restored default IP address:
192.168.3.10
A voice message announces that the loudspeaker amplifier is rebooting.
The loudspeaker amplifier reboots.
Table 2-14. Factory Default Settings
Factory Default Setting
static
192.168.3.10
admin
admin
255.255.255.0
192.168.3.1
930111F
Installing the VoIP Loudspeaker Amplifier
Restore the Factory Default Settings
CyberData Corporation
29