CyberData VoIP Loudspeaker Amplifier Part #010859 Operation Manual page 32

24 Installing the VoIP Loudspeaker Amplifier
Set up the MGROUPS
Web Page Item
Device Name
MG-Emergency
MG-(1-8)
MG-Background
Multicast IP Address
Port 2000-65535
Priority
MGROUP Name
Beep
CyberData Corporation
2. On the MGROUPS Setup page, enter values for the parameters indicated in
3. After changing the parameters, click Save Settings.
Table 2-12. MGROUPS Setup Parameters
Description
Displays the device name.
Use MG-Emergency for the MGROUP with the highest
priority.
Use MG-(1-8) to assign MGROUPS 1 through 8.
Use MG-Background for the MGROUP with the lowest
priority (background audio for example).
Enter the multicast IP Address for this MGROUP.
Enter the port number for this MGROUP.
Assign the priority for this MGROUP (the higher the number,
the higher the priority).
Assign a descriptive name for this MGROUP.
Check this box if you want a beep to precede a page.
Click this button to save your configuration settings.
Click this button to reboot the system.
Link to the Network Setup page.
Link to the Speaker Setup page.
Link to the SIP Setup page.
Link to the Upgrade Firmware page.
Link to the Home page.
930111F VoIP Loudspeaker Amplifier Operations Guide
Table 2-12.