Configure The Sip Parameters - CyberData VoIP Loudspeaker Amplifier Part #010859 Operation Manual

20 Installing the VoIP Loudspeaker Amplifier
Configure the Loudspeaker Amplifier Parameters
Web Page Item
RTFM Announcement

2.3.4 Configure the SIP Parameters

Note
CyberData Corporation
Table 2-10. Loudspeaker Amplifier Setup Parameters (continued)
a
a.If you select No for RTFM Announcement, you will not hear a beep or associated RTFM audio.
However, the return to default settings function remains active. If you wish to return to default
settings, hold the RTFM button at least 20 seconds, then release the button.
3. After changing the parameters, click Save Settings.
1. Click SIP Setup to open the SIP Setup page
For specific server configurations, go to the following URL:
http://www.CyberData.net/support/voip
Description
Enable/Disable the speaker tone (beep) and audio
associated with the RTFM switch.
Click on this button to save your configuration settings.
Changing a parameter that has an asterisk next to it will
cause a system reboot when saved.
Click on this button to do an audio test. Generates a voice
message for testing the speaker audio quality and volume.
Link to the Network Setup page.
Link to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Upgrade Firmware page.
Link to the Home Page page.
(Figure 2-15).
930111F VoIP Loudspeaker Amplifier Operations Guide