Omron FZ3 User Manual page 42

The screen returns to the RUN window.
1
Important
When [Transfer data] is executed, the results of [Trend Monitor] and [Expression], etc. are cleared.
●
If the scene or scene group was switched or any setting of a processing unit was changed during operation
●
using an external command, the result is not yet reflected when you switch to the non-stop adjustment window.
If non-stop adjustment is performed after changing the scene group during operation, scene group data may be
●
overwritten against your wish.
Measurement commands (parallel, non-procedure, PLC link) and continuous measurement commands (parallel
●
only) are the only communication commands that are accepted during data transfer.
Data transfer takes a longer time when the scene group file size is larger.
●
If the RUN window is displayed in the fast view mode, non-stop adjustment cannot be performed.
●
Communication settings cannot be changed on the non-stop adjustment window.
●
Do not register any new camera image input unit on the non-stop adjustment window.
●
If RAMDisk does not have enough free disk capacity, data may not be transferred. Specify an image logging
●
destination other than RAMDisk or otherwise set applicable items to minimize the usage of RAMDisk.
Performing non-stop adjustment changes the display mode to freeze.
●
If image logging is performed in the non-stop adjustment mode, data transfer may be disabled. To prevent this
●
from happening, set the trigger interval longer than the logging time.
40 Setting Operation Mode FZ3 User's Manual