Table of Contents
Advertisement
Note
When the communication specification "Output Control" is set to "Synchronization output", levels will be
●
counted according to the number of times the STEP signal turns on. For this reason, perform settings so that
results are output only once for each measurement. (1 unit for [Judgement Output], 1 data item for [Data
Output])
Reference:
Only designate the STEP signal for measurement command input.
●
When measurement using serial commands and continuous measurement are performed, the output time will
not match and this can cause controller malfunctions.
Example) Stepped transmission line utilizing star wheel
The discharge timing for when a defective part is found and the measurement results output timing can
be synchronized.
7
Inputting a measurement trigger in the STEP signal
Example) When "2" is set for "Number of delay"
222
Controlling/Outputting through Parallel Communication
Setting Communication Specifications (Parallel Interface) (p.211)
FZ3 User's Manual
Advertisement
Table of Contents
