Table of Contents
Advertisement
Saving Settings and Turning Power Off
Before turning off power to the controller, perform the following operations to save the data that you
have set.
1
The controller loads scene data from the flash memory each time during start-up. Therefore, if the power
is turned off without saving data to the flash memory, any changes made will not be saved.
1.
On the Main screen (ADJUST window), tap [Data save] in the toolbar to save the setting data.
2.
Exit after powering off the controller.
Note
Data to be saved
●
Scene data and system data are saved in the controller. Logging images and data saved in the RAMDisk
are not saved. Perform any of the following procedures to keep this data.
- Copy data saved in the RAMDisk to the USB memory.
Reference:
- Change the save destination of logging data to USB memory.
Reference:
When using the scene group function
●
The scene data set in Scene group 0 is saved in the controller. The scene data from scene groups 1 to
31 is saved to the USB memory and overwrites previous saved data. (For FZ3-9
are saved in the controller.)
Turning Off LCD
This function is specific to FZ3-300/700/900 series LCD-integrated controllers.
Turn off the LCD only without turning off the controller.
1.
Open the measurement manager bar at the bottom right of the Main screen and tap [LCD Off].
A confirmation message is displayed.
2.
Tap [OK].
28
Saving Settings and Turning Power Off
Copying/Moving Files (p.124)
Saving Logging Images to RAMDisk/USB Device (p.122)
/H9
, all data
FZ3 User's Manual
Advertisement
Table of Contents
