Table of Contents
Advertisement
Setting item
Address setting
Obtain an IP address automatically
●
[Use the following IP address]
●
IP address
Subnet mask
Default gateway
DNS server
I/O setting
Input mode
Input form
Output IP address
Input/Output port No.
[Note 1]: It is not displayed if the communication module is set to "Normal (TCP)".
[Note 2]: The initial setting value becomes [9876] only when the communication module is set
to [Normal (TCP)].
Reference:
Setting the Start-up Status [Startup Setting] (p.133)
3.
Tap [OK].
The settings are confirmed and the Ethernet window closes.
FZ3 User's Manual
Setting value
[Factory default]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 0 to 255
[10.5.5.100]
0.0.0.0 to
255.255.255.255
[255.255.255.0]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 0 to 255
[10.5.5.110]
a.b.c.d
a: 1 to 223
b: 0 to 255
c: 0 to 255
d: 0 to 255
[10.5.5.1]
[Normal]
[ASCII]
a.b.c.d
a: 1 to 223
b: 0 to 255
[Note 1]
c: 0 to 255
d: 0 to 255
[0.0.0.0]
0 to 65535
[9600] [9876]
[Note 2]
Controlling/Outputting through Serial Communication (Non-procedure)
Description
Set the IP address of the controller.
When "Obtain an IP address
automatically" is selected, the IP
address of the controller will be
automatically obtained.
When "Use the following IP address"
is selected, set the IP address,
subnet mask, and the default
gateway address.
Input the controller IP address.
Input the subnet mask address.
Input the default gateway address.
Input the DNS server address.
This item cannot be changed.
This item cannot be changed.
Input the output destination IP
address.
Set the port No. to use for data I/O
with the controller. Set the same No.
as on the host side.
7
179
Advertisement
Table of Contents
