CX-Programmer Procedures
Reading and Transferring Data Link Tables
Reading Data Link Tables
1,2,3...
Select this button to display the
Communications Units mounted on
the PLC .
2. Select PLC and then Open. When connected, the display will change as
follows:
Turns green
Shows connection status and PLC mode.
Select PLC and then Open to reconnect if disconnected.
Read the data link tables that have been created and then transfer them to all
the nodes participating in the data links.
1. Start the CX-Net and select Data Link and then Setup. If connected locally
(i.e., directly to the PLC), the Data Link Setup (Local) Dialog Box will ap-
pear.
If connected remotely (i.e., through a network), the Data Link Setup (SYS-
MAC LINK) Dialog Box will appear.
2. Select SYSMAC LINK and then click the OK button. The following dialog
box will appear.
Section 4-12
Open the data link table file (*.sl3). Refer to Data
Link Setup (SYSMAC LINK) Dialog Box Func-
tions below for other button functions.
79