Omron CS1W-SLK11-21 - 06-2004 Manual page 37

Cable Connections
Connection Procedure
1,2,3...
Cable Connection
1,2,3...
20
The connection procedure is described briefly below.
1. Install connectors on each end of the cables.
2. Connect Terminator to the F Adapter at each end of the network (i.e., to the
unused connectors at the last Unit on each end). Hold the connector in one
hand and press the resistance into it firmly with the other.
3. Connect the F Adapters to the SYSMAC LINK Units by firmly pushing the
adapter onto the coaxial connector on the Unit and turning the locking ring
to the right until it locks. Start at one end of the network and connect the F
Adapters to the other end in order.
F Adapter
Connector
Terminator
1. Firmly press the F-Adapter into the Unit, and turn the locking ring to the
right until it locks.
Turn locking ring to
the right.
5C-2V coaxial cables
Section 2-4
Terminator