Data Link Procedures; Manually Setting Data Links - Omron CS1W-SLK11-21 - 06-2004 Manual

Data Link Procedures

Using a Personal Computer as a Node
Note
1-5

Data Link Procedures

1-5-1

Manually Setting Data Links

1,2,3...
10
IBM PC/AT or compatible
CX-Net in
CX-Programmer
+
SYSMAC LINK
Support Board
Setting data link tables
Software
CX-Programmer
(1) The CS-series SYSMAC LINK Units cannot be directly connected to
SYSMAC Support Software.
(2) For further details about the CX-Programmer, refer to the CX-Program-
mer Operation Manual.
(3) The CX-Net in the CX-Programmer cannot set data link tables for the
C200H-SLK21 or C1000H-SLK21. Refer to 9-3 Using the C200H-SLK21
or C1000H-SLK21 for details.
When the data link mode is set for manual data link table creation, the data
link tables can be input using the CX-Net within the CX-Programmer. Use the
following procedure.
1. Install and wire the Units.
Contents
a. Mount the Units to
the PLCs.
b. Wire the Network.
c. Connect terminat-
ing resistance
2. Prepare for communications.
Contents
a. Set the unit num-
ber.
b. Set the node
address.
External Model
appearance
WS02-CX@@E
Method
--- All nodes
--- All nodes
Use C100H-TER01 Coaxial systems only.
Terminator.
End nodes on the net-
work: Connect Termi-
nator
Method
Use the front rotary CS-series, CVM1, and
switches. CV-series PLCs only
Use the front rotary All nodes
switches.
Section 1-5
Nodes Page
18
19
Nodes Page
18