Omron CS1W-SLK11-21 - 06-2004 Manual page 94

CX-Programmer Procedures
Note If using CX-Programmer Ver. 1.2 (Service Pack 1), select "CV/CVM1" for the
PLC type when using a CS-series SYSMAC LINK Unit. With CX-Programmer
Ver. 2.0 or later, CS-series PLC types can be specified.
3. Click the OK button. As shown below, a data link table will be automatically
created for all nodes in the Nodes Valid Field. All nodes will have the same
start words and the same send sizes, and the refresh order set in the same
order as the node addresses.
This completes the data link tables creation. Next, check and save the data
link tables using the following procedures.
Section 4-12
77