Omron CS1W-SLK11-21 - 06-2004 Manual page 156

Error Log
Error Contents
code
0012 CPU Unit memory error
Hex
0013 CPU Unit write-protected
Hex
0101 Transmission failed; local node
Hex not in Network
0103 Transmission failed; retry count
Hex exceeded
0104 Transmission failed; maximum
Hex number of frames exceeded.
0105 Transmission failed; node
Hex address incorrect
0106 Transmission failed; redundant
Hex node address
0107 Transmission failed; destination
Hex node not in Network
0108 Transmission failed; specified
Hex Unit does not exist
Detail code
1st byte 2nd byte
01 Hex: Read 01 Hex:
error Data link
02 Hex: Write table
error 02 Hex: Net-
work param-
eters
03 Hex:
Routing
table
04 Hex: PLC
Setup Area
Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Correction
Set the appropriate data.
Release the CPU Unit write
protection.
Refer to page 8-1-1 Error Indi-
cations and place the local
node into Network.
Using the CX-Net or FINS
commands, run echoback
tests and check operating
environment if errors occur.
Reduce the number of events
per communications cycle or
increase the maximum num-
ber of network parameter
frames.
Check node address settings
to be sure they are within
range and unique.
Correct node addresses so
that they are unique within the
same Network.
Refer to 8-1-1 Error Indica-
tions and place destination
node into Network.
Check the unit address and
unit number of destination.
Section 8-2
Written to
EEPROM
Yes
Yes
No
No
No
No
No
No
No
139