Omron CJ - PROGRAMMING MANUAL 08-2008 Programming Manual page 24

SYSMAC WS02-CX@@-V@
CX-Programmer Operation Manual
SYSMAC WS02-CX@@-V@
CX-Programmer Operation Manual: Function Blocks
@@
(CS1G-CPU H, CS1H-CPU
@@
CJ1H-CPU H, CJ1M-CPU
@@@@ @
CP1H-XA - , and CP1H-Y
SYSMAC CS/CJ Series
Programming Consoles Operation Manual
CQM1H-PRO01-E, CQM1-PRO01-E, C200H-PRO27-E
SYSMAC CS/CJ Series
@@
CS1W-SCB -V1, CS1W-SCU
@@
CJ1W-SCU -V1
Serial Communications Boards/Units Operation Manual
SYSMAC WS02-PSTC1-E
CX-Protocol Operation Manual
CXONE-AL@@C-V3/AL@@D-V3
CX-Integrator Operation Manual
CXONE-AL@@C-V3/AL@@D-V3
CX-One Setup Manual
!WARNING
Failure to read and understand the information provided in this manual may result in per-
sonal injury or death, damage to the product, or product failure. Please read each section
in its entirety and be sure you understand the information provided in the section and
related sections before attempting any of the procedures or operations given.
xxiv
Name
@@ @@
H, CJ1G-CPU H,
@@ @@@@ @
, CP1H-X -
@@@@ @
- CPU Units)
@@
-V1,
Cat. No.
W446 Provides information on how to use the CX-Pro-
grammer for all functionality except for function
blocks.
W447 Describes specifications and operation methods
related to function blocks. This information is
required only when using function blocks.
,
W341 Provides information on how to program and
operate CS/CJ-series PLCs using a Programming
Console.
When programming, use this manual together
with the Programmable Controllers Operation
Manual (W339 for CS-series PLCs and W393 for
CJ-series PLCs), CS/CJ-series Programmable
Controllers Programming Manual (W394,) and
the CS/CJ-series Programmable Controllers
Instructions Reference Manual (W340).
W336 Describes the use of Serial Communications Unit
and Boards to perform serial communications
with external devices, including the use of stan-
dard system protocols for OMRON products.
Refer to the CS/CJ Series Communications Com-
mands Reference Manual (W342) for details on
sending commands in host link mode from a
Serial Communications Board or Unit's port.
Refer to the WS02-PSTC1-E CX-Protocol Opera-
tion Manual (W344) for details on creating proto-
col macros.
W344 Describes the use of the CX-Protocol to create
protocol macros as communications sequences
to communicate with external devices.
W464 Describes operating procedures for the CX-Inte-
grator Network Configuration Tool for CS-, CJ-,
CP-, and NSJ-series Controllers.
W463 Installation and overview of CX-One FA Inte-
grated Tool Package.
Contents