App Description (Input And Output Screen); Refer To - Optex Virtual Loop Installation Instructions Manual

8-4 4-6

App description (Input and output screen)

- Check and change the input / output settings of the sensor.
Input and output
Application Barrier Protection 90 deg
Indicator
Indicator
Heater
Heater
Output 1
Mode
Output type
Pulse time duration
Delay
Hold timer
EOL
Output 2
Mode
Output type
Pulse time duration
Delay
Hold timer
RS485 channel
RS485 baud rate
RS485 EOL
RS485 protocol
Input
Mode
Contact
Caution
- After changing the settings, tap the send icon to send the settings to the sensor.
■ Applications
Change it by selecting Menu Icon > Favorite > Select application.
● Indicator
[1] Indicator
Refer to page 30
The operation indicator is lit when the sensor makes a
detection during operation. The operation indicator can
Normal be selected to On or Off.
● Heater
[1] Heater
Detection
Refer to page 30
Pulse IN
Normally set this to Normal.
150ms
● Output
0.5s
[3] Mode
0.5s
Refer to page 31
Off
[4] Output type
Refer to page 31
Detection
[5] Pulse time
Pulse IN
Refer to page 31
150ms
[6] Delay
0.5s
Refer to page 32
0.5s
[7] Hold timer
0
Refer to page
0
● RS485 (GT model does not use)
0
[8] RS485 channel
0
[9] RS485 baud rate
[10] RS485 EOL
Link(OR gate)
[11] RS485 communication protocol
High
Set according to the connected device.
● Input
[12] Mode
[13] Contact
Set according to the connected device.
3229
-29-