Installation - Optex Virtual Loop Installation Instructions Manual

7-2

Installation

[1] Loosen the screws on the top and bottom covers, and remove the covers.
* Do not loosen the screws completely. The screws may fall out.
If a screw is lost, use an M3 × 6 Philips screw.
[2] Detach the sensor unit by lifting it.
When using a conduit pipe
NOTE
When using conduit pipe, remove the rubber grommet.
The rubber lid is difficult
to reattach if it is detached
completely.
Flip it up to reach the screw.
-15-
Top cover
Bottom cover