Installation
3. Connect the below listed wires from the outlets. Use the illustration above as a
reference:
4. Tighten the screws to the correct torque. For the specification, refer to section
12.4.
6.3.6
Connect the DC power cables
Preliminary requirements
46
Outlet
Wire
1
(A) L1 wire
(B) neutral wire
(C) PE wire
2
(D) L2 wire
(E) neutral wire
(F) PE wire
3
(G) L3 wire
(H) neutral wire
(I) PE wire
4
(J) L4 wire
(K) neutral wire
(L) PE wire
•
Torque wrench
•
Wire cutter
•
Wire stripper pliers
•
DC power cables (for each
outlet: one positive, one
negative). Refer to section
12.13.5.
•
Cable lugs 3/8"
Note: For the specific connections, refer to the installation brief, the
installation drawing and the installation manuals of the devices installed
in the system you ordered.
Connect to terminal
X2-1
X2-2
X2-3
X2-4
X2-5
X2-6
X3-7
X3-8
X3-9
X3-10
X3-11
X3-12
•
HVC 200/300/360-EN | 002