Maintenance And Cleaning; Maintenance Schedule; Do A Check On The Cabinet; Clean The Evse - ABB HVC 200 Operation And Installation Manual

Maintenance and cleaning

9 Maintenance and cleaning
9.1

Maintenance schedule

Task
Do a check for damage on the
EVSE.
Clean the power cabinet.
Make sure that the manufac-
turer does maintenance on the
EVSE.
9.2

Do a check on the cabinet

1. Do a check for damage on these parts:
2. If you see damage, contact the manufacturer. Refer to section 1.11.
9.3

Clean the EVSE

Preliminary requirements
Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a a solution of cleaning agent to the surface and let it soak.
3. Manually remove dirt. Use the non-abrasive tool.
4. Rinse with low-pressure tap water.
5. If necessary, apply wax on the front for extra protection and gloss.
6. If there was rust and you want it not to appear again, apply a rust-preventive
primer. Ask the manufacturer for specifications and instructions.
66
Part
Beacon
Coating of the EVSE
• Cleaning agent. Refer to section 12.6.
• Non-abrasive tool. Refer to section 12.6.
Danger:
Hazardous voltage
• Do not apply high-pressure water jets. Water can leak into the EVSE.
Note: When the EVSE is put in a corrosion sensitive environment,
superficial rust is possible on welding points. This rust is only visual.
There is no risk for the integrity of the EVSE. The procedure below
removes the rust.
Caution: Do not use abrasive tools.
Frequency Procedure
1 week Refer to section 9.2.
3 months Refer to section 9.3.
1 year or after re- Ask the manufacturer to
placement of a part schedule the maintenance
service. Refer to section 1.11.
Damage
Cracks
Cracks or ruptures
HVC 200/300/360-EN | 002