Removing Nodes From The Chassis; Removing The Cover From The Node - Supermicro FatTwin F618R3-FT User Manual

FatTwin F618R3-FT USER'S MANUAL
6-5

Removing Nodes from the Chassis

Each of the eight individual nodes may be removed from the chassis. Note that
when a node is removed from the chassis, the hard drives located in the node will
shut-down.
Removing a Node
1. Power down the system and remove the power cords from the rear of the
node as described in Section 6-3.
2. Grasp the node by the handles on either side of the front of the node.
3. Pull down the left side handle to release the locking mechanism.
4. Carefully pull the node forward and out of the chassis.
6-6

Removing the Cover from the Node

Removing the Node Cover
1. Remove the power cord from the node as described in Section 5-2 and
remove the node from the chassis as described in Section 5-4.
2. Remove the two screws on either side of the rear of the node.
3. Lift the cover up and off the node.
Figure 6-3: Removing the Node Cover
6-4