Table of Contents
Advertisement
6-3
Removing the Power Cord
Before performing any setup or maintenance on the chassis, use the following
procedure to ensure that power has been removed disconnected from the system.
Removing the Power Cord
1. Use the operating system to power down the system, following the on-screen
prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply.
3. If your system has dual redundant power supplies, remove the cords from
both power supplies.
4. Disconnect the cord from the power strip or wall outlet.
6-4
Installing and Removing the Node Drawers
The F418IL chassis contains eight individual serverboards in separate node drawers
(Figure 6-2). Each serverboard node controls a set of two hard drives. Note that if
a serverboard node drawer is pulled out of the chassis, the hard drives associated
with that node will power down as well.
Figure 6-2: Hard Drives and the Corresponding Serverboards
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
