Table of Contents
Advertisement
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper JPME2
to bypass SPI flash security and force the
system to operate in the Manufacturer
mode, allowing the user to flash the
system firmware from a host server for
system setting modifications. See the
table on the right for jumper settings.
SAS Enable (For X10DRFF-C Only)
Jumper JPS1 allows you to enable the
onboard SAS connectors. The default
setting is 1-2 to enable the connection.
See the table on the right for jumper
settings.
5-10 Onboard Indicators
GLAN LEDs
There are two GLAN ports (JLAN1/2) on
the serverboard. Each Ethernet LAN port
has two LEDs. The Yellow LED on the
right indicates connection and activity.
The Link LED on the left side may be
green, amber or off to indicate the speed
of the connection. See the tables at right
for more information.
Chapter 5: Advanced Serverboard Setup
ME Mode Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Link Speed
LED
GLAN Activity Indicator
(Right) LED Settings
Color
Off
Yellow
LAN Connection Speed
Indicator (Left) LED Settings
LED Color
Off
Green
Amber
5-21
Definition
Normal (Default)
Manufacture Mode
SAS Enable
Definition
Enabled (Default)
Disabled
GLAN LED
Activity
LED
Status
Definition
No Connections
Flashing
Active
Definition
10 MHz
100 MHz
1 GHz
Advertisement
Table of Contents
