FatTwin F618R3-FT USER'S MANUAL
5-2
Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfigured systems to prevent them from blocking the flow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are configuring the system, keep the airflow in mind when routing the cables.
Refer to Chapter 1 for details on cables used in the F618R3-FT server.
5-3
I/O Ports
The rear I/O ports are in conformance with the PC 99 specification. See Figure 5-1
below for the colors and locations of the various I/O ports.
1
Back Panel I/O Port Locations and Definitions
1
2
3
4
5
6
7
Figure 5-1. Rear I/O Ports
2
3
4
Back Panel USB 3.0 Port 1
Back Panel USB 3.0 Port 2
Gigabit LAN Port 1
Gigabit LAN Port 2
IPMI LAN Port
VGA Port
Power Switch LED
5
6
5-2
7