5-10 Onboard Indicators - Supermicro SuperStorageSystem SSG-2028R-DN2R24L User Manual

SUPERSTORAGESYSTEM SSG-2028R-DN2R24L User's Manual
LAN Enable/Disable
JPL1 enables or disables onboard LAN
Ports 1/2 on the motherboard. These
LAN ports support 10 Gigabit Ethernet
LAN connections. See the table on the
right for jumper settings. The default
setting is Enabled.
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper JPME2
to bypass SPI flash security and force the
system to operate in the manufacturer
mode, which will allow the user to flash
the system firmware from a host server
for system setting modifications. See the
table on the right for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable the
embedded ASpeed AST2400 Baseboard
Management Controller (BMC) to
provide IPMI 2.0/KVM support on the
motherboard. See the table on the right
for jumper settings.
LAN Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
ME Mode Select
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacture Mode
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Disabled
5-18

5-10 Onboard Indicators

LAN LEDs
There are two LAN ports on the I/O
backpanel. These LAN ports support
10 - Gigabit LAN connections. Each
LAN port has two LEDs. The Yellow
LED on the right indicates activity. The
Link LED on the left side may be green,
amber or off to indicate the speed of the
connection. See the tables at right for
more information.
BMC Heartbeat LED
A B M C (Baseboard M anagement
Controller) Heartbeat LED is located at
LEDH (BMCHB) on the I/O backpanel,
which is the top LED indicator on the
backpanel. When this LED is blinking,
BMC is functioning normally. See the
table at right for more information.
System Heartbeat LED
The System Heartbeat LED is located
at LEDL (SYSLED) on I/O backpanel.
When this LED is blinking, your system
is normal. See the table at right for more
information.
Chapter 5: Advanced Motherboard Setup
GLAN LED
Link Speed Activity
LED LED
LAN Port Activity LED (Left)
LED State
Color Status Definition
Orange Flashing Active
10Gbps LAN Link
LED Settings
Color Definition
Off No Connection,
10 or 100 Mbps
Green 10 Gbps
Amber 1 Gbps
BMC Heartbeat LED States
Color/State Definition
Green: Blinking BMC: Normal
System Heartbeat LED States
Color/State Definition
Green: Blinking System: Normal
5-19